QuickFinder Nail Clippers

Directions

1. Before clipping, examine feet and nails for signs of injury. Feet and nails should be free of injury and dry before proceeding with nail clipping.
2. Power Up: To power on the unit and keep powered up slightly squeeze handles together until red light only is illuminated (continue to keep handles slightly squeezed together to keep power on). If all lights illuminate and remain on, there is insufficient power and batteries must be replaced. If green light stays on, turn unit off by releasing handles, wait two seconds for unit to reset and restart power up phase again. Once red light stays illuminated unit has sufficient battery power and is ready for operation.
3. With unit powered up (red light on), insert nail into fixed blade hole from under side of clipper. Keep nail at 90° angle and against sensor side of the fixed blade hole. Move cutting blades toward base of nail far enough that quick in the nail will be detected for the first time. The red light will flicker and remain on. This sets the sensor to the quick in the nail. Note that the nail should continually be on the sensor side of the hole during sensing for sensing to occur.
4. Maintaining power to unit, move cutting blades back towards nail tip away from nail base. The yellow light may briefly illuminate as blade and sensor approaches nail without quick.
5. Continue moving cutting blades outward until green light illuminates indicating a safe cut. It is not safe to clip when yellow or red lights are on.
6. While maintaining position and angle (90°) of clipper, squeeze handles together in firm swift motion to avoid crushing nail. It is normal for green light to turn off at end of clipping action after blade has cut through nail.
7. If red light stays on, power off device and restart clipping process (Step 1).
8. The QuickFinder will automatically turn off in open position (Handles not depressed).

Cautions

• Do not disassemble the QuickFinder. There are no adjustments or repairs that can be made.
• If properly used, the QuickFinder will tell you where it is safe to clip your pet's nail. If by accident the blade comes in contact with the quick, use styptic powder, corn starch or powder to stop the bleeding. If bleeding does not stop take your pet to an emergency room.
• When using an electrical appliance, basic precautions should always be observed, including the following.
• WARNING: KEEP OUT OF REACH OF CHILDREN. DO NOT USE IN WATER. For external use only. This is not a toy and should be handled with extreme care.
• Do not put anything except the pet's nail into this tool.
• Use appliance for its intended use only.
• Store at room temperature, away from heat and moisture.
• Store in the off position (handles left open).
• Store unit and extra batteries out of reach of infants, children and pets.
• Remove batteries during prolonged periods of non-use.
• Keep out of water.
• Avoid static electricity.
• As with any product, use care while using tool on your pet.