Dri-Dek Roll, 3' x 12'

Size up the area you wish to cover.

Layout the Dri-Dek Rolls^® in the desired configuration.

Point the outer tabs of the Rolls in the same direction.

For large areas, install in independent sections approximately 10x10 to allow for ease of cleaning, maintenance and normal expansion and contraction from temperature variations.

Snap the pins into the tabs along the entire section. For larger installations, you may want to use a hammer to tap the pins into the tabs. Hammering can be done from the bottom of the roll or the top of the roll.

Trim for a wall-to-wall fit around irregular shapes.

Maintenance:

• To reach drained dirt simply roll back and sweep or rinse away with water.
• To clean the surface, hose it off with water or brush with detergent and rinse with water.
• For high use areas or in a barefoot environment, use a 2000-3000psi high pressure washer on both the top and bottom of the surfaces to remove any build-up of organic material.
• Frequency of cleaning is determined by usage.
• Proper maintenance will increase the performance and useful life of your surface.

Not recommended for use in small quantities on slippery or polished surfaces.

Do not use this product where high-heeled shoes may be worn.

Not intended for use as a running surface.